2026-08-09

泡沫 - 坐垫 - 驾驶位座椅（拆卸和更换）

校正代码 13070102 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See 人员保护 to make sure wearing proper PPE when performing the below procedure. NOTE: See 人体工程学注意事项 for safe and healthy working practices.

  • 2026-01-20: 添加了“本程序中需要更换新的占用传感器”的信息。
警告
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.
注
本程序中需要更换新的座椅占用传感器。

安装

  1. 将新的占用传感器安装到新的座椅座垫泡沫垫上。
    注
    去除粘合保护层，然后将占用传感器固定在泡沫垫上的指示标记之间。
  2. 将占用传感器连接器穿过泡沫垫，然后将塑料外壳安装到连接器线束上。
  3. 安装驾驶位座椅座垫饰板。请参阅 套 - 坐垫 - 驾驶位座椅（拆卸和更换） ((拆卸和更换))