18/05/2023 20:44:17

踏板垫 - 制动(拆卸和更换)

校正代码 33251202 0.12 注意:除非本程序中另有明确规定,否则上述校正代码和 FRT 反映的是执行本程序(包括关联程序)所需的所有工作。除非明确要求,否则请勿堆叠校正代码。注意:请参阅平均维修工时,深入了解 FRT 及其创建方式。要提供有关 FRT 值的反馈,请发送电子邮件至LaborTimeFeedback@tesla.com注意:请参阅人员保护,确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。

拆卸

  1. Open the LH front door and lower the LH front window.
  2. Move the driver front seat rearward.
  3. Release the retaining flaps on the rear of the brake pedal pad, and then peal the pad from the pedal to remove it.

安装

  1. Use IPA wipes to clean the brake pedal, and then position a mirror behind the pedal for installation.
    Informational PurposesAn informational icon, calling your attention
    Allow 1 minute for the IPA to dry.
  2. Apply a thin layer of P-80 Emulsion temporary rubber assembly lubricant to the mounting grooves on the brake pedal pad, and then insert a wire into the top groove of the brake pedal pad.
    Informational PurposesAn informational icon, calling your attention
    The wire should be approximately 300mm long and 16-18 AWG. Allow an equal length of wire on each side of the pad. The wire will be used to ease installation.
  3. While pushing down on the center of brake pedal pad, secure the pedal into the three grooves on LH and RH sides and bottom, and then rotate the pad into position.
    Informational PurposesAn informational icon, calling your attention
    Make sure the LH and RH sides and bottom retaining flaps are fully secure.
  4. While applying pressure to the top of brake pedal pad, pull the ends of the wire forward to engage top retaining flap to brake pedal.
    Informational PurposesAn informational icon, calling your attention
    Make sure all four retaining flaps are secured to brake pedal.
  5. Move the driver seat to the original position.
  6. Raise the LH front window and close the LH front door.