Cover - Camera - Rear Facing (Remove and Install)
Correction code
1722040501
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2026-03-31: Added information to skip camera calibration.
Remove
-
Remove the rear facing
camera from the camera cover. See Camera - Rear Facing (Remove and Install).
NoteDo not disconnect the rear facing camera for this procedure.
Install
-
Install the rear facing camera to the camera cover. See Camera - Rear Facing (Remove and Install).
NoteSkip the instructions for Service Mode and Clear Camera Calibration if the camera was not disconnected for this procedure.