Center Console - Airwave Assembly (Model YL) (Remove and Replace)
Correction code
15190202602
FRT
0.72
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
-
Remove the center console airwave assembly. See Airwave Assembly - Center Console (Model YL) (Remove and Replace).
NoteDuring removal, certain steps require extra care. See the animation(s) for detailed guidance.
Install
- Install the center console airwave assembly. See Airwave Assembly - Center Console (Model YL) (Remove and Replace).
- Locally connect a laptop with Toolbox to the vehicle. See Toolbox (Connect and Disconnect).
- Click the Actions tab, type "TEST-SELF_VCUSB_X_HVAC-ACTUATOR" into the search field, click TEST-SELF_VCUSB_X_HVAC-ACTUATORvia Toolbox:(link), click Run, and allow the routine to complete.
-
Click the
Actions tab, type "PING-BASH_DISPLAY" into the search field,
click PING-BASH_DISPLAYvia Toolbox:(link), select rear at the
Poppyseed Display Test Arg
field, and change the timeout to20
, then click Run, and allow the routine to complete. - Disconnect the laptop.
- On the touchscreen, press and hold the Exit Service Mode button to exit Service Mode Plus.