2026-09-08

Light - Dome - 3rd Row Seat - Pair (Model Y L) (Remove and Replace)

Correction code 15200204302 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-09-08: Released new procedure.

Remove

  1. Open all four doors and lower all four windows.
  2. Move the 2nd row seats backward.
    Note
    Adjust the seat back if needed to avoid contacting other components.
  3. Remove the rear map light bezels. See Bezel - Map Light - Rear - LH (Model YL) (Remove and Replace).
  4. Open the liftgate.
  5. Remove the rear headliner. See Rear Headliner (Model YL) (Remove and Replace).
  6. Release the clips (x2) and location pin to partially release the rear center section of the headliner from the body.
  7. Carefully insert an inflatable airbag between the rear section of the headliner and the body, and inflate the airbag for enough space to access the dome light.
    CAUTION
    Take care not to damage the headliner.
  8. Disconnect the LH 3rd row seat dome light connector.
  9. Remove the screw that attaches the LH 3rd row seat dome light to the headliner, and then release the tabs (x2) to remove the light from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  10. Repeat step 8 and 9 to remove the RH 3rd row seat dome light.

Replace

  1. Align the tabs (x2) to install the light to the vehicle, and then install the screw that attaches the LH 3rd row seat dome light to the headliner.
    0.65 Nm (6 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  2. Connect the LH 3rd row seat dome light connector.
  3. Repeat 1 and 2 to install the RH 3rd row seat dome light.
  4. Deflate the inflatable airbag, and then remove it from the vehicle.
  5. Install the clips (x2) and locator pin to secure the rear center section of the headliner to the body.
  6. Install the rear headliner. See Rear Headliner (Model YL) (Remove and Replace).
  7. Install the seal at the rear center section of the headliner.
    Note
    Ensure that the seal covers the interior trim panel.
  8. Close the liftgate.
  9. Move the LH 2nd row seat back to its original position.
  10. Install the rear map light bezels. See Bezel - Map Light - Rear - LH (Model YL) (Remove and Replace).
  11. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): TEST-SELF_VCLEFT_REAR-DOME-LIGHTSvia Toolbox:(link)
  12. Exit Service Mode or disconnect the laptop if applicable (see 0005 - Service Modes).
  13. Reinstall the software. See Software Reinstall - Touchscreen.
  14. Raise all four windows and close all four doors.