Correction code 62100100905 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

1. Run ODIN routine TEST-SELF_VCLEFT_X_WIPERvia Service Mode:Closures ➜ Windows ➜ Wiper Testvia Toolbox:(link)
2. On the vehicle touchscreen, select Service Mode > Driver Assist > Cameras > Grid Button (in lower corner of camera preview) > Clean Cameras . Verify that the camera cleaning system works as expected and that the air stream clears previously dispensed fluid. Record the results in SCA.
   Note

   **Via Service mode>Driver Assist>Cameras>Grid button on lower left>Clean cameras, Ensure air stream clears previously dispensed fluid as expected, Record results in SCA
3. Open the hood.
4. Fill the washer fluid reservoir.
5. Close the hood.