2026-11-02

Clevis Clip - Brake (Remove and Replace)

Correction code 33253102 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-10-30: Released new procedure.

Remove

  1. Open LH front door
  2. Lower LH front window
  3. Move LH front seat backward
  4. Release LH footwell cover
    Note
    2x magnets, 2x datums, Cover is attached to carpet, Configurations may vary by region
  5. Remove LH knee air bag cover
    Note
    1x connector, 8x tabs, 2x datums
  6. Remove LH footwell duct from HVAC module
    Note
    1x clip, Pull LH footwell duct towards LH side of vehicle to remove
  7. Remove cotter clip from clevis pin on brake pedal assembly
    Note
    1x clip
  8. Remove clevis pin from brake pedal assembly
    Note
    1x pin

Install

  1. Align brake pedal to iBooster rod and install clevis pin to brake pedal assembly
    Note
    1x pin
  2. Install LH footwell duct to HVAC module
    Note
    1x push clip
  3. Install LH knee air bag cover
    Note
    1x connector, 8x tabs, 2x datums
  4. Secure LH footwell cover
    Note
    2x magnets, 2x datums
  5. Move LH front seat to original position
  6. Raise LH front window
  7. Close LH front door