2026-09-25

Sensor - Pressure Tube - Pedestrian Protection (Remove and Replace)

Correction code 2020011002 FRT 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-12-19: Added post-replacement routine.
CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Airbag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Install

  1. Install the pedestrian protection pressure tube sensor to the bumper beam foam. See the Bumper Beam Foam (Remove and Replace).
  2. Connect the LV battery power. See LV Power (Disconnect and Connect) (Modify).
  3. Unlock the vehicle gateway, See Gateway (Unlock).
  4. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_RCM_X_SERVICE-TASKSvia Service Mode Plus:Safety & Restraints ➜ Safety Testing ➜ RCM Service Tasksvia Toolbox:(link)
  5. Exit Service Mode.
  6. Raise the LH front window and close the LH front door.