21/12/2022 06:05:14

Target Calibration - Forward Facing Camera

Correction Code 17230600

Special tool required for this procedure:

Supplier Part Number Description
Tesla 1053066-00-A Camera Calibration Target
Informational PurposesAn informational icon, calling your attention
Note
This procedure is only for vehicles with 1st generation Autopilot.
Informational PurposesAn informational icon, calling your attention
Note
If the Camera Calibration Target is not available, perform a drive cycle calibration Drive Cycle Calibration - Forward Facing Camera.
Informational PurposesAn informational icon, calling your attention
Note
Note: This procedure describes how to calibrate the forward facing camera. It does not apply to the rear facing camera.

Setup

  1. If the vehicle is equipped with air suspension, set the ride height to Medium.
  2. Park the vehicle on a flat surface with at least 106 cm (3.5 ft) of space in front of the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the vehicle has air suspension, ensure that the suspension is level and set to "Medium".
  3. Set up the target tripod so that the bottom of the target is 90 cm (3 ft) from the ground.
    1 90 cm (3 ft)
  4. Place the target in the appropriate starting position (this is "Location 1" in the Toolbox 3 procedure):
    • The checkered portion of the target is facing towards the vehicle
    • The target is centered with the Tesla "T" on the front fascia
    • The target has 2 legs facing the vehicle and both are less than 5 mm from the lower valance
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to damage component(s).
  5. Ensure that the target is on flat ground by examining the bubble level on the back of the target.
  6. Apply a piece of tape on the ground behind the tripod leg that is farthest from the vehicle.
  7. Apply another piece of tape 90 cm (3 ft) behind the tape that was applied in the previous step. This is "Location 2" in the Toolbox 3 procedure.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not move the target to Location 2 at this point.
    1 90 cm (3 ft)
  8. Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect).

Target Calibration

  1. Using Toolbox 3:
    1. Select the Actions tab and search for "SPTAC".
    2. Select the ODIN routine PROC_DAS_X_SPTACSearch for routine in Toolbox, and then click the link of the routine.
    3. Click RUN and follow the onscreen instructions to calibrate the forward facing camera.
  2. When prompted, move the target from "Location 1" to "Location 2".
    Location 1 Location 2
  3. Once the calibration procedure is completed, click X to close the pop-up.