2026-08-09

Sensor - Parking Distance - Inner - Front (Remove and Replace)

Correction Code 17271012

Note
This procedure applies to front parking sensors 2, 3, 4, and 5.

Removal

  1. Remove the front fascia assembly (refer to procedure).
  2. Disconnect the electrical harness from the parking sensor.
    Tip
    If needed, use a small flat head screwdriver to release the locking tab.
  3. Release the tabs that attach the parking sensor to the fascia bracket, and then remove the sensor from the bracket.
    Tip
    If needed, use a pick or small flat head screwdriver to release the bracket tabs.
  4. If reusing the retainer ring, remove the retainer ring and inspect for damage.
    CAUTION
    Do not reuse the ring if it is overly worn or damaged.

Installation

Installation procedure is the reverse of removal, except for the following:

CAUTION
Make sure a retainer ring is installed on the new parking sensor.
CAUTION
Make sure the fascia sensor bracket tabs are securely holding the sensor. If necessary, carefully bend the tabs inward so that the sensor is securely held in place.
Note
Perform a push-pull-push test on the electrical harness to verify proper connection.
Note
Make sure the sensor retainer ring is fully seated against the fascia.