2026-08-09

Brake Rotor - Front - LH (Remove and Replace)

Correction Code 33010102

Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Special tool(s) required for this procedure:

Supplier Part Number Description
Tesla 1082171-00-A S-hook
Note
For detailed brake specifications, see Brakes.
  • 2025-05-08: Updated brake pad burnishing step to be performed after rotor replacement.

Removal

  1. Remove the road wheel (refer to procedure).
  2. If the brake pads are being replaced, remove them from the caliper (refer to procedure).
    Note
    If the pads are not being replaced, continue this procedure.
  3. Note the orientation of the clip that secures the brake hose to the suspension spring module. Release the clip.
  4. Remove and discard the bolts (x2) that secure the caliper to the knuckle (torque 120 Nm).
  5. Release the caliper and use the S-hook to support it.
  6. Remove the screw that secures the rotor to the hub (torque 17 Nm).
  7. Remove the rotor.

Installation

Installation procedure is the reverse of removal, except for the following:
Note
Clean the affected areas before installation.
CAUTION
Ensure brake hose is aligned correctly with no excessive twist or bends.
CAUTION
Replace all patchbolt(s).
  • Ensure that the clip that secures the brake hose to the air spring module is installed correctly.
    • Rear wheel drive (RWD) vehicles: The hose and the clip are installed from the same direction.
      Note
      Ensure that the clip is fully seated, with the “fingers” both remaining on the bottom side of the retaining bracket.
      Top view, RWD (correct)Bottom view, RWD (correct)
    • Dual motor (DM) vehicles: The clip is installed from the rear.
      Note
      Ensure that the clip is fully seated, with the “fingers” both remaining on the bottom side of the retaining bracket.
      Top view, DM (incorrect)Top view, DM (correct)Bottom view, DM (correct)
  • Pump the brake pedal at least 5 times to seat the pads against the brake rotor.
    Warning
    Always check that the brake pads are seated correctly before driving the vehicle.
  • Burnish the brakes. See Brake Pads - Burnishing.
    Note
    During vehicle driving, make sure that proper brake pedal feel and performance is achieved.
    Note
    Add the correction code for brake pad burnishing 33013000 as a separate correction within the same activity to the Service Visit.