2025-06-16
Brake Pads - Park Brake - Set (Remove and Replace)
Removal
Warning
If the vehicle has air
suspension, activate "Jack" mode on the touchscreen before raising and
supporting the vehicle.
- Raise and support the vehicle (refer to procedure).
-
Put the parking brake in Service Mode. Perform the following
routine using Service Mode or Toolbox (see 0005 - Service Modes):PROC_EPB_X_SERVICE-MODEvia Toolbox: (link)via Service Mode:
- Chassis ➜ Brakes ➜ EPB Service Mode
- Chassis ➜ Brakes ➜ EPB Service Mode
NoteIn the event of a stuck caliper or motor failure, refer to one of these procedures to release the caliper: - Remove the road wheels (refer to procedure).
- Remove the retaining pins and anti-rattle spring.
- Remove the brake pads from the caliper.
Installation
Installation procedure is the reverse of removal, except for the following:
Note
Clean the affected areas before
installation.
- Release the park brake caliper to make sure the new brake pads will fit. Refer to Park Brake Caliper - Release - Harness Tool - Through Calipers.
- Thoroughly clean the caliper pad slides with locally-accepted brake cleaner and ensure that the brake pads move freely. After cleaning the slides, apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
- Burnish the parking brake pads. See Brake Pads - Park Brake - Burnishing.