2026-09-25

Link - Stabilizer Bar - Front - LH (Remove and Replace)

Correction Code 31012002

Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.
CAUTION
If performing this procedure as a result of a collision, see the Collision Repair Manual to verify whether the steering gear must be replaced as well.

Removal

  1. Loosen the front LH lug nuts (torque 175 Nm).
  2. Raise and support the vehicle (refer to procedure).
  3. Remove the road wheel (refer to procedure).
  4. Dual Motor vehicles: Remove the brake dust shield (refer to procedure).
  5. Remove and discard the nut that secures the link to the knuckle (torque 70 Nm).
    CAUTION
    To prevent ball joint damage, always hold the ball joint pin with a wrench while loosening or tightening the lock nut.
  6. Remove and discard the nut that secures the link to the stabilizer bar (torque 70 Nm).
    CAUTION
    To prevent ball joint damage, always hold the ball joint pin with a wrench while loosening or tightening the lock nut.
  7. Remove the stabilizer bar link from the vehicle.

Installation

  1. Installation procedure is the reverse of removal.
    CAUTION
    Replace all nylon-insert locknuts.