22/09/2022 11:32:51

Integral Link - Rear - LH (Remove and Replace)

Correction Code 31034102

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Removal

  1. Remove the road wheel (refer to procedure).
  2. Remove the nut and bolt that secure the link to the knuckle (torque 130 Nm).
  3. Removethe nut and bolt that secure the link to the lower control arm (torque 130 Nm).
  4. Remove the integral link from the vehicle.

Installation

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
Note
Clean the affected areas before installation.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Replace all nylon-insert locknuts.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Only fully tighten suspension nuts and bolts when the vehicle is on a 4-post lift and the suspension is in the ride height position.
  1. Transfer the vehicle to a 4 post lift (refer to procedure).
  2. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.