2025-04-14

Mount - Front Drive Unit - RH (2nd Generation) (Remove and Replace)

Correction code 39012422 6.9 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-04-14: Added note to separately add correction code 18200102 for refrigerant recovery/recharge and condensed procedure.
  • 2023-09-19: Updated torque value for RH side mount bolts.
This procedure is for vehicles built after April 24, 2019. For vehicles built through April 24, 2019, see Mount - Front Drive Unit - RH (1st Generation) (Remove and Replace).
Informational PurposesAn informational icon, calling your attention
Note
This procedure requires the A/C Refrigerant (Recovery and Recharge) procedure to be performed. If not already automatically added to the Service Visit, add correction code 18200102 as a separate activity to the Service Visit.

Installation

  1. Install the RH side mount to the front drive unit, and then install and hand-tighten the bolts (x4) that attach the mount to drive unit.
  2. Install the RH side mount onto the front drive unit, and then fully tighten the bolts (x4) that attach the RH side mount onto the front drive unit.
    60 Nm (44.2 lbs-ft) +50 degrees
  3. Install the front drive unit. See Drive Unit - Front (2nd Generation) (Remove and Install).