16/11/2022 04:16:23

Module - Door Controller - LH (Remove and Replace)

Correction Code 11332402

Removal

  1. Remove the door trim panel (refer to procedure).
  2. Disconnect the door module harness connectors (x3).
  3. Remove the screws (x3) that secure the control module to the door panel (torque 2 Nm).
  4. Remove the door controller module.

Installation

Installation procedure is the reverse of removal, except for the following:
  1. Update the vehicle firmware. See Firmware Update.
    Informational PurposesAn informational icon, calling your attention
    Note
    The front and rear doors on the applicable side of the vehicle must be open while performing the firmware update.
  2. Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect).
  3. Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock.
  4. Using Toolbox 3:
    Informational PurposesAn informational icon, calling your attention
    Note
    The below ODIN routine needs to be run when the LH door controller module is replaced. When the RH door controller module is replaced, use ODIN routine PROC_DDM_DRV_PEKTRON-VIN-LEARNSearch for routine in Toolbox instead.
    1. Select the Actions tab and search for "Pektron VIN learn".
    2. Select the ODIN routine PROC_DDM_DRV_PEKTRON-VIN-LEARNSearch for routine in Toolbox, and then click the link of the routine.
    3. Click RUN, and allow the routine to complete.