07/10/2020 13:16:37
Fixed Glass Roof Rack (Retrofit)
Correction Code 24300006
This procedure describes the removal of a first generation fixed glass roof and subsequent retrofit of a 2nd generation fixed glass roof that supports the installation of a roof rack.
Special tools required for this procedure:
| Supplier | Part Number | Description |
| Tesla | 1080599-00-A | SSC209 Vacuum Cups (2 sets) |
| Tesla | 1064740-00-A | Adhesive Scraper Tool |
| Tesla | 1080619-00-A | JN1130-Wire Starter |
| Tesla | 1078736-00-A | SWL165 Squire Wire (164ft roll) |
| Tesla | 1078806-00-A | LWH200 Griptite |
Parts required for this procedure.
| Part Number | Description | Qty |
| 1490009-00-A | ASY FIXED GLASS ROOF RACK MOUNT BLOCK | 4 |
| 1052779-00-A | GASKET, ROOF RACK BRKT | 8 |
| 1116867-00-A | NUT,HF,M6-1.0,[8],ZNNI[B] | 8 |
| 1018062-00-A | CAP,HEX,M6[Plastic]-DOME | 8 |
| 1490219-00-B | MODEL S, FIXED GLASS ROOF, NARROW | 1 |
Note
These part numbers were current at
the time of publication. Use the revisions listed or later, unless otherwise
specified in the Parts Catalog.
Procedure
- Remove and discard the fixed roof glass per local regulations. See Roof - Glass (Remove and Replace) .
- Install 1 gasket on each fixed glass roof rack mount block stud (x8).
- Position the fixed glass roof rack mount blocks on the vehicle, and then tighten the nuts (x8) that attach the mount blocks to the vehicle (torque 11 Nm).
- Install 1 plastic dome hex cap over each fixed glass roof rack mount block stud (x8).
- Install the new fixed roof glass. See Roof - Glass (Remove and Replace) .
