Wheelhouse Insulator - Rear - RH (Remove and Replace)
Correction code
15300401
15300402
FRT
0.96
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
- 2026-10-20: Updated the steps of removing the insulator by cutting it open.
- 2025-12-01: Released new procedure.
Remove
- Open all four doors and lower all four windows.
- Open the liftgate.
- Remove the subwoofer. See Subwoofer (Remove and Replace).
-
Release the clips (x2) that secure the RH body harness to the RH side trunk
bulkhead.
-
Release the RH body harness clip from the C-pillar and pull the harness backward to
move it away from the body.
-
Cut the RH rear wheelhouse insulator near the RH body harness to allow for the
removal of the insulator.
-
Remove the RH rear wheelhouse insulator from the vehicle.
Install
- Cut the RH rear wheelhouse insulator near the RH body harness to allow the harness to be routed into the insulator's opening hole.
-
Install the RH rear wheelhouse insulator to the vehicle.
-
Install the body harness back into position and secure the clip that attaches the
RH body harness to the C-pillar.
-
Secure the clips (x2) that attach the RH body harness on RH side trunk
bulkhead.
- Install the subwoofer. See Subwoofer (Remove and Replace).
- Close the liftgate.
- Raise all four windows and close all four doors.