2026-11-17

Door Assembly - Front - LH (Remove and Install)

Correction code 10106001 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat backward.
  3. Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  4. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  5. Disconnect the connectors (x2) for the door harness and remove the retainer clip from the VCLEFT.
  6. Release the grommet, then remove the LH front door harness from the A-pillar area.
    Note
    Push the harness through the bulkhead from the A-pillar area.
  7. Support the LH front door with a floor jack.
    Note
    Protect the painted surface with a soft object.
  8. Remove the bolts (x2) that attach the LH front door upper hinge to the door assembly.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
  9. With assistance, remove the bolts (x2) that attach the LH front door lower hinge to the door assembly, and then remove the LH front door assembly.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. With assistance, install the bolts (x2) that attach the LH front door lower hinge to the door assembly.
    31 Nm (22.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Install the bolts (x2) that attach the LH front door upper hinge to the door assembly.
    31 Nm (22.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
  3. Remove the floor jack from the LH front door.
  4. Verify the seal is fully seated around the black grommet, and then route the LH front door harness through the outer A-pillar.
  5. Secure the LH door harness connectors (x2) and the clip to the VCLEFT.
  6. Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  7. Connect the LV battery power. See LV Power (Disconnect and Connect).
  8. Move the LH front seat to the original position.
  9. Raise the LH front window and close the LH front door.
  10. Check the gap and flush of the front door to the surrounding components.