2026-08-09

HV Header - Inverter - Rear Drive Unit - LH (Plaid) (Remove and Replace)

Correction code 40206312 3.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear subframe. See Subframe Assembly - Rear (Plaid) (Remove and Replace).
  2. Release the harness clip, and then disconnect the LH rear drive unit LV connector.
  3. Slide the red connector locking tab, open the black release lever, and then disconnect the LH rear drive unit HV harness from the LH rear drive unit inverter.
    CAUTION
    Do not force the release lever up.
  4. Remove and discard the bolts (x2) that attach the LH rear drive unit inverter HV header to the LH rear drive unit inverter.
    6 Nm (4.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  5. Line up the drive unit header removal tool onto the header, firmly engage the lever inwards to release the locking tabs, and then remove the header housing while the tool is still installed.
    Note
    Use a plastic trim tool as needed.
    Tip
    Use of the following tool(s) is recommended:
    • Drive Unit HV Header Removal Tool - 1142608-00-C
    • Plastic trim tool
  6. Use a pick to carefully release the clips (x6) that attach the retainer to the rear drive inverter, and then remove the retainer.
    Note
    Take note of original position.
    Note
    Save the retainer for installation.

Install

  1. Install the retainer onto the LH rear drive unit inverter HV header.
    Note
    Make sure the clips (x6) are fully engaged.
  2. Position the LH rear drive unit inverter HV header onto the LH rear drive inverter, and then press the header into the inverter.
    Note
    An audible click should be heard.
    Note
    Perform a push-pull-push test to verify the header is fully seated.
  3. Install new bolts (x2) that attach the LH rear drive unit inverter HV header to the LH rear drive unit inverter.
    6 Nm (4.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  4. Perform an inverter lair leak test. See Inverter Air Leak Test (On Table).
  5. Connect the LH rear drive unit LV connector, and then install the harness clip.
  6. Verify that the black release lever of the rear drive unit HV harness connector is in the open position, install the connector flat and square to the HV battery LH HV header, secure the release lever to the closed position, and then slide the red connector locking tab.
  7. Install the rear subframe. See Subframe Assembly - Rear (Plaid) (Remove and Replace).