2026-10-23

Solenoid Bracket - Air Spring Module - Front - LH (Remove and Replace)

Correction code 31012802 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-10-19: Released new procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Remove the LH front wheel cap.
  4. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  5. Disconnect the LH damper harness connectors from the LH front air spring module.
  6. Release the clips that attach the LH front damper harness to the solenoid bracket.
  7. Release the tabs (x2) and remove the solenoid bracket from the LH front air spring module.

Install

  1. Install the solenoid bracket to the LH front air spring module.
  2. Position the clips that attach the LH front damper harness to the solenoid bracket and route the harness for installation.
  3. Connect the LH damper harness to the LH front air spring module.
  4. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  5. Install the LH front wheel cap.
    Note
    Align the valve stem with the cap.
  6. Remove the vehicle from the lift.
  7. Raise the LH front window and close the LH front door.