D-Pillar Reinforcement
Correction code:
10101914402
10101914502
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | PNL - D-PILLAR REINF (D-Pillar Reinforcement) | |
| 5 | Structural Bulb Rivet, 6.5 mm | |
| 1 | Flow Form Rivet S38 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the Quarter Outer. Refer to the correct procedure for the vehicle
being repaired:
-
Remove the original component.
or Factory Spot Weldsor Drill through factory spot weldsNoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the Quarter Outer. Refer to the correct procedure for the vehicle
being repaired:
-
Install the fastener as indicated.
or Flow Form Rivets, S38
- A = 8 mm.
- B = 7 mm.
- Perform any necessary post-repair operations.