2026-08-09

Brake Caliper - Rear - Park Brake - LH (Remove and Replace)

Correction Code 33052002

Removal

  1. Put the parking brake in Service Mode. Perform the following routine using Service Mode or Toolbox (see ):PROC_EPB_X_SERVICE-MODEvia Service Mode:
    • Chassis ➜ Brakes ➜ EPB Service Mode
    • Chassis ➜ Brakes ➜ EPB Service Mode
    via Service Mode Plus:Drive Unit ➜ Rear Drive Unit Replacement ➜ Release / Re-Engage Emergency Parking Brakevia Toolbox:(link)
    Note
    In the event of a stuck caliper or motor failure, refer to one of these procedures to release the caliper:
  2. Remove the LH rear wheel (refer to procedure).
  3. If the new caliper does not have brake pads: Remove the brake pads from the caliper (refer to procedure).
  4. Disconnect the electric parking brake caliper harness connector.
  5. Remove and discard the bolts (x2) that secure the caliper to the knuckle (torque 57 Nm).
  6. Remove the parking brake caliper.

Installation

Installation procedure is the reverse of removal, except for the following:
  • Use a M10 x 1.5 tap to clean the mounting holes in the knuckle.
  • Clean the affected areas before installation.
  • Apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides. Remove any excess lubricant.
  • Burnish the parking brake pads. See .