2026-10-15
Sensor - Crash Accelerometer - LH ((拆卸和更换))
校正代码
20201152
FRT
0.36
注意：除非本程序中另有明确规定，否则上文所列校正代码及相关 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。
注意：请参阅平均维修工时深入了解 FRT 及其创建方式。
注意：请参阅人员保护确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。
注意：请参阅人体工程学注意事项查看安全健康的作业规程。
警告
本程序为“草案”。虽已通过验证，但可能仍有“警告”和“注意”事项缺失。请遵守安全要求，处理或靠近高压系统和部件时，请谨慎操作。
- 2026-06-24: Released new procedure.
警告
如果维修或处理不当，辅助约束系统 (SRS) 部件可能引发危害。请参阅 气囊和辅助约束系统 (SRS) 预防措施
警告
气囊或座椅安全带预紧装置一旦展开，必须更换特定部件，并检查其他部件是否损坏。请参阅《碰撞维修手册》查看必须检查和更换的零件的详细清单。
- Open the LH front door.
- Lower the LH front window.
-
Open the hood.
-
Power off the vehicle using the touchscreen.
-
Remove the rear underhood apron.
-
Disconnect the LV battery connector and First Responder Loop.
-
Remove the RH underhood apron.
-
Remove the LH underhood apron.
-
Remove the front underhood apron.
-
Remove the underhood storage unit access panel.
-
Remove the underhood storage unit carpet.
-
Remove the underhood storage unit from the vehicle.
-
Disconnect connector from shotgun accelerometer
注1x connector, pull red locking tap
-
Removed bolt from sensor
注1x bolt, 10mm, 7Nm
-
Remove shotgun accelerometer
注1x tab
-
Install shotgun accelerometer
注1x tab
-
Install bolt in sensor
注1x bolt, 10mm, 7Nm
-
connect connector to shotgun accelerometer
注1x connector, push red locking tap
-
Install the underhood storage unit.
-
Install the underhood storage unit carpet.
-
Install the underhood storage unit access panel.
-
Install the front underhood apron.
-
Install the LH underhood apron.
-
Install the RH underhood apron.
-
Connect the First Responder Loop and LV battery connector.
-
Install the rear underhood apron.
- Close the hood.
-
Calibrate LH and RH Falcon Wing doors from center display
注Calibration required after LV system is powered down > Service > Calibrate Doors > Hold down Calibrate doors until doors cycle > Calibration Complete Message will appear
- Raise the LH front window.
- Close the LH front door.