2026-10-27

Retractor - Seatbelt - 2nd Row - RH (5 Seat) (Remove and Replace)

Correction code 20056212 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2026-10-27: Added SRS safety note. Added note to refer to Collision Repair Manual for list of components to inspect or replace after a collision.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Air Bag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.
  1. Remove the RH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - RH (5 Seat) (Remove and Replace).
  2. Release the locking tab, and then disconnect the seat belt harness electrical connector.
  3. Remove and discard the bolt that attaches the RH 2nd row seatbelt retractor assembly to the seat frame, and then remove the assembly from the seat frame.
    45 Nm (33.2 lbs-ft)
    Note
    Slide the retractor assembly out of the retaining slot. Route the seatbelt over the guide and through the escutcheon cover after removal of the retractor.
    Note
    Use of the following tool(s) is recommended:
    • T50 socket
  4. Position the RH 2nd row seatbelt retractor assembly onto the seat frame, and then install a new bolt that attaches the assembly to the seat frame.
    45 Nm (33.2 lbs-ft)
    Note
    Route the seatbelt through the backrest frame and over guide through the escutcheon cover. Slide the retractor assembly into the retaining slot.
    Note
    Use of the following tool(s) is recommended:
    • T50 socket
  5. Connect the seat belt harness electrical connector, and then secure the locking tab.
  6. Install the RH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - RH (5 Seat) (Remove and Replace).